Tip number 10 for superior performing fasteners
With reference to tips 1 & 3 this week we focus on, “use a 304 grade bolt with a 316 grade nut”
Reference – interesting article – superior performing fasteners tips and tricks.
As a fastener business we often get some hard questions about fasteners. Sometimes though, we get questions that seem obvious to us because we have been in the industry for so long. Its hard to tell when something is common knowledge or simply something we know because we work in the industry. To remedy this, we highlight 1 quick tip each week for using fasteners that outline some of the basics of fasteners we think everyone should know.
Use a 304 grade bolt with a 316 grade nut
Galling or cold welding can also occur when the same grade of stainless steel is used. When the same grade of stainless steel is used they can also stick or weld together. That’s why we recommend you use a 304 grade bolt with a 316 grade nut.
Our products are not just high quality and high performers – they are “superior performing fasteners”. If you need it, we’ll find it. If we can’t find it, we’ll suggest a workable alternative or tailor-make a solution for you.
Read:
- Why you shouldn’t use 18-8 stainless steel in or near a salt water environment
- How to use hot dip galvanised fasteners
- Why you shouldn’t use stainless steel and aluminum together
- Always use fastener lubricant on stainless steel fasteners
- Why you should always use the right size screwdriver
- The right driver bit for the right screw head
- Always pre-drill hardwood before installing screws
- Do not mix fine and coarse thread fasteners
- Don’t over-tighten fasteners
- You’re not invincible, wear safety gear
Check back next week for Fastener tips and tricks number 11
HOW TO ORDER / GET A QUOTE: Our stress-free, three-step ordering service makes life easier.
